I mop my tiles with Pine Sol and then let it dry. Should I be going over it again w/ a fresh bucket of water?

I usually mop my tiles with Pine Sol and then let it dry. Should I be going over it again with a fresh bucket of water? Does a once over clean and disinfect property or is it not enough?


Thanks

I mop my tiles with Pine Sol and then let it dry. Should I be going over it again w/ a fresh bucket of water?
If you use it straight then yes. It can leave a residue.


If you put some in with water to begin with, you should be just fine.





I love pine-sol !
Reply:That should be sufficient, unless the floor is unusually dirty and your water gets too nasty. Even then, I imagine you would change the water.
Reply:I use pine sol also, but I mix a little bit of bleach in with the water, I hate germs... And it works very well.
Reply:Pine Sol %26amp; water works well without rinsing. I loved the smell of it, too. However, I found when washing venetian blinds that Pine Sol, Mr. Clean, etc.. (even after rinsing) still maintained an invisible residue. Liquid Spc N Span did not leave this residue nor needed rinsing.

larry